Machine Pressed

• Top diameter large than bottom
• Mass production with high MOQ
• No embossed pattern on outer wall
• Simple pattern inwall is available

• Inwall Max-Min thickness: 1.5~10mm
• Bottom thickness: 4~30mm
• Low cost
• Simple shape containers

Machine Blown

• Most of the products can be made with mouth big bottom small or mouth small bottom big.
• The cup is formed by turning the radius once according to the center line of the cup (it must be rotated in the grinding tool). The cup body can not have a pattern or other logo. The shape cannot be a polygon.
•  The cup mouth of the machine blown product has a heat burst ring and a drip head.
•  The body of the machine blown cup will have the abrasive grain (because the material is rotating in the abrasive, abrasive grain in the cup body is showing a horizontal effect.
•  The wall thickness is generally between 1-1.5mm or between 1-1.2mm. he European 90 machine wall thickness can be 1.8MM
•  The bottom thickness is around 0.5-2CM.
•  The wall thickness is getting thicker and thicker from top to bottom.
•  The bottom of the cup is not very flat, some may have some lines.

Hand-Blown

The basic process of hand-blow-made type is small bubble, large bubble, blow molding, shaping and pre-furnace heat processing, pre-furnace heat processing includes inding, expansion, shaping, etc.

Different shapes of glass products, blowing method of the process is not the same. Glassware according to the operating process can be divided into burst products and open products.

Generally, there is no seam line in the hand-blown cup.

• The cup wall is relatively thin.
• Most of the cups have slight bubbles and streamlines.
• The specifications are slightly different.